Pipe Coatings by IPS.

pipe coating HomeVideo Contact Us
pipe coating
State-of-the-Art Technology
IntraCoat Pipeline Services, Inc., known world-wide as "IPS" is the international leader of internal pipeline cleaning and coating. Pipeline pigs are used to mechanically and chemically clean the full length of the pipeline. To complete the IntraCoat process, pipeline pigs apply our unique corrosion-resistant epoxy coating.

Primary Services

Pipe Coating

Pipeline Corrosion Protection

Pipeline Cleaning

Epoxy Coating Pipes

Pipeline Pigging Maintenance

IntraCoat Provides Pipe Coatings
pipe coatings

Pipe Coating

A pipe coating should be pre-selected and tested to operate sufficiently in its operating environment. It must have an adequate pot-life to allow for enough time to load the batch into the pipeline, run the length of the line and recover the excess coating at the receiver. In long lines of 20 miles or more, a 6- 8 hours pot-life is needed. Pipeline Coatings used in the in-situ coating process used by IPS normally has a solid content in the range of 70-85%, with a typical viscosity of between 95-120 kreb units.

Most coating projects are designed to apply approximately 2 to 3 mils of coating per coating run, and normally require 3 to 4 coats to achieve the typical contracted dry film thickness (DFT). The drying time between coating runs is typically 16 to 24 hours.

The coating pigs will be modified, just before pipeline coating, to allow for the wall thickness of the pipeline and to allow for the type of coating to be used. Each pipeline has its own unique characteristics, which create some ambiguities with the first coating run. Normally, the first coating run will target a mil thickness just thick enough to fill the surface profile.

When the excess coating arrives at the receiver, it is removed and is normally placed back into its original container. The amount of coating received is recorded, with the difference between the amounts loaded and received, indicating the applied mil thickness for the pipe coating, as based on the manufacturer’s theoretical spreading rate.

Pipe Coating & Corrosion Protection

If you are concerned about pipeline corrosion, call IPS to learn aout our pipe coating process or pipeline rehabilitation. Our pipe coatings, sometimes called in-situ coating are performed with your pipeline in place.
 
 
 

June 9, 2009



Kevin Cato
IntraCoat Pipeline Services, LP
2450 Chambers St.
Venus, Texas 76084


ABSTRACT[More]
 
December 23, 2006
Known world-wide as IPS, we have updated our name to better reflect our state-of-the-art technology. We are now called Intra . . . [More]
 


   Contact Us
IntraCoat
Pipeline Services

P.O. Box 696
Mansfield, Texas 76063

2450 Chambers Street
Venus, Texas 76084

Tel. (817) 477-1008
Fax (817) 225-0945
Toll Free 1(800) 742-3102



Pipe Coating Info


© 2007 IntraCoat Pipeline Services, Inc. All rights reserved. IntraCoat Pipeline Services, Inc is a division of IPS International, Ltd.
Latest News | About Us | Pipeline Cleaning & Coating | Internal Pipeline Cleaning
Pigging Services & Programs | Pipeline Abandonment | Contact Us | This is a HandsomeWeb.